It's the first cold night, you turn up the thermostat and nothing happens. Before you panic, a few simple checks fix a surprising number of "dead" furnaces. Here's what to look at, in order.
Safety first: if you smell gas, don't touch any switches, don't try to light anything and don't look for the leak. Get everyone out of the house and call 911 from outside. The same goes if a carbon monoxide alarm sounds.
1. The thermostat
- Is it set to Heat, and set a few degrees above the room temperature?
- Does the screen have power? Many thermostats run on AA or AAA batteries, and a blank or flickering screen usually means it's time for new ones.
- If it's a programmable or smart thermostat, check that a schedule or "away" mode isn't holding the temperature down.
2. The power
- Check your electrical panel for a tripped breaker marked furnace, air handler or HVAC.
- Look for a switch on or near the furnace that looks like a light switch. It's easy to flip off by mistake, especially when someone is storing things in the utility room.
3. The filter
A badly clogged filter can make a furnace overheat and shut itself off for safety, sometimes after running only a few minutes. If you can't see light through it, change it.
4. The front panel
Furnaces have a safety switch that keeps them off when the front door panel isn't fully seated. If the panel was taken off to change a filter, make sure it's snapped back on all the way.
5. The drain line (high-efficiency furnaces)
High-efficiency gas furnaces, the ones with white plastic vent pipes, make water as they run. If the drain line or the little condensate pump clogs or freezes, the furnace shuts down to keep from flooding. Look for water around the furnace or a pump that's full.
6. Oil furnaces
- Check the oil tank gauge. Running out of oil can pull sludge into the line, and it may need a service call even after a delivery.
- The burner has a red reset button. You can press it once. If the burner doesn't start, or it locks out again, stop and call us. Pressing it over and over can pump extra oil into the burner, which is dangerous.
7. The status light
Most furnaces have a small window with a blinking light. Count the blinks and match them to the chart on the inside of the panel door. Even if you can't fix it, telling us the code helps us bring the right part.
When to call
If you've worked through the list and it still won't start, or it starts and shuts off over and over, or you hear banging, squealing or rumbling, it's time for a pro. We repair gas and oil furnaces of most brands across St. Mary's and Calvert. Book a furnace repair online any time, or call (301) 880-3248, Monday through Friday, 8 AM to 5 PM.
Most no-heat calls are caught early by a yearly furnace tune-up, where we clean and test the parts that usually fail first. Members of our maintenance plans get one every fall without having to remember.

